Compression molding

Compression molding :   

          Compression molding is a method of molding in which the molding material, generally preheated, is first placed in an open, heated mold cavity. The mold is closed with a top force or plug member, pressure is applied to force the material into contact with all mold areas, while heat and pressure are maintained until the molding material has cured. The process employs thermosetting resins in a partially cured stage, either in the form of granules, putty-like masses, or preforms. Compression molding is a high-volume, high-pressure method suitable for molding complex, high-strength fiberglass reinforcements. Advanced composite thermoplastics can also be compression molded with unidirectional tapes, woven fabrics, randomly oriented fiber mat or chopped strand. The advantage of compression molding is its ability to mold large, fairly intricate parts. Also, it is one of the lowest cost molding methods compared with other methods such as transfer molding and injection molding; moreover it wastes relatively little material, giving it an advantage when working with expensive compounds. However, compression molding often provides poor product consistency and difficulty in controlling flashing, and it is not suitable for some types of parts. Fewer knit lines are produced and a smaller amount of fiber-length degradation is noticeable when compared to injection molding. Compression-molding is also suitable for ultra-large basic shape production in sizes beyond the capacity of extrusion techniques. Materials that are typically manufactured through compression molding include: Polyester fiberglass resin systems (SMC/BMC), Torlon, Vespel, Poly(p-phenylene sulfide) (PPS), and many grades of PEEK.

          Compression molding was first developed to manufacture composite parts for metal replacement applications, compression molding is typically used to make larger flat or moderately curved parts. This method of molding is greatly used in manufacturing automotive parts such as hoods, fenders, scoops, spoilers, as well as smaller more intricate parts. The material to be molded is positioned in the mold cavity and the heated platens are closed by a hydraulic ram. Bulk molding compound (BMC) or sheet molding compound (SMC), are conformed to the mold form by the applied pressure and heated until the curing reaction occurs. SMC feed material usually is cut to conform to the surface area of the mold. The mold is then cooled and the part removed. Materials may be loaded into the mold either in the form of pellets or sheet, or the mold may be loaded from a plasticating extruder. Materials are heated above their melting points, formed and cooled. The more evenly the feed material is distributed over the mold surface, the less flow orientation occurs during the compression stage.
          In compression molding there are six important considerations that an engineer should bear in mind :

• Determining the proper amount of material.
• Determining the minimum amount of energy required to heat the material.
• Determining the minimum time required to heat the material.
• Determining the appropriate heating technique.
• Predicting the required force, to ensure that shot attains the proper shape.
• Designing the mold for rapid cooling after the material has been compressed into the mold.

 ADVANTAGES:

• Lowest cost molds
• Little "throw away" material provides advantage on expensive compounds
• Often better for large parts
• Lower labor costs
• Minimum amount of wasted material & Improved material efficiency
• Internal stress and warping are minimized.
• Dimensional accuracy & stability is excellent.
• Shrinkage is minimized and closely reprodcible.
• Thick sections and large parts are practical.
• Lower molding pressures allow molding of large parts on presses of lower tonnage.

DISADVANTAGES:

• Offers least product consistency
• Not suitable for fragile mold features, or small holds
• Uneven parting lines present a mold design problem
• High impact composites make flash control & removal difficult.
• The depth of the molded holds is limited to 2 or 3 times their diameter
• Shot weight must be tightly controlled
• Dimension across the parting line may be difficult to hold but good accuracy may be obtained through tight process control.